LPG Flooring · Ongar
Subfloor Preparation & Latex Levelling in Ongar
From £18/m² (up to £32/m²)
Every flooring failure we get called to repair across IG7, IG9, IG10 and CM16 traces back to one thing: a subfloor that was not prepared properly. So we run subfloor levelling as a standalone service, including for floors we did not fit. The job covers latex feathering of high spots, self-levelling compound (SLC) for general dips, deep-fill repair for hollow chases and trenches, ply overlay on suspended timber, and full damp-proof membrane installs where moisture readings come back wet. We bring our own dust extraction. The brand promise is literal · we obsess over subfloor preparation, and we will tell you when yours is fine and a level is not needed.
Between timber-framed history and modern slabs, CM5 floors are unpredictable · we investigate, then level, and never gamble a wood floor on an unknown base. Chipping Ongar (CM5) and its satellite villages · High Ongar, Fyfield, Moreton and the Rodings · sit between Epping and Brentwood in proper commuter-belt countryside. The High Street keeps its Georgian and older timber-framed fabric, while the lanes carry farmhouses, cottages and generous modern plot builds. Older CM5 properties need the same care as Abridge: solid floors of unknown build-up, occasional lime construction, and cottage staircases that are rarely square, which makes hand-cut carpet and scribed wood the only honest way to fit. Newer executive homes around Love Lane and Shakletons take wide-plank engineered oak and deep wool carpets. Around 20 minutes from the workshop via the A414.
Warranty: 10-year structural-stability warranty on prepared subfloor · Postcodes: CM5
How we fit subfloor levelling in Ongar
- Step 1. Diagnostic survey: moisture meter readings logged on a property plan, SR-level check with a 2m straight edge, hollow-sounding zones mapped, photo report supplied.
- Step 2. Demolition: existing tile, screed or adhesive residue mechanically removed where required, dust-extracted at source so the rest of the property stays clean.
- Step 3. Priming: appropriate primer matched to the substrate (acrylic for concrete, dual-component for non-porous, SBR slurry for timber overlays).
- Step 4. Pour & spread: self-levelling compound mixed to spec with a forced-action mixer, poured in 4–6m² zones, spike-rolled to release air, finished within open time.
- Step 5. Cure & verify: 24-hour minimum cure, re-survey with the straight edge to confirm SR2 (or SR1 for resin/wood floors), dated written report handed over with the next-trade clearance certificate.
Frequently asked questions
How much does subfloor levelling cost in Ongar?
In Ongar, a latex feather skim to take out high spots runs £18–22/m². A full self-levelling compound pour at 3–6mm depth is £24–28/m². Deep-fill repair (over 10mm · typical of removed kitchen islands or filled floor chases) is £32+/m². We always quote against a measured survey, not a phone-call estimate, because any flooring contractor giving you a levelling price without seeing the floor is guessing.
Why does subfloor preparation matter so much?
Because a luxury flooring product is only as good as the substrate it is bonded to. The British Standard BS 8204 Part 1 specifies an SR2 finish (3mm deviation under a 2m straight edge) as the minimum for resilient and wood floors. An out-of-tolerance subfloor causes lipping, hollow points, premature wear, adhesive failure and joint peaking. About 60% of the wear and life of an Amtico, LVT or engineered-wood floor is decided by what is underneath it.
Can you do levelling without me having a flooring fitter?
Yes · we run subfloor levelling as a standalone service for Ongar contractors, kitchen fitters and homeowners doing their own LVT install. We hand over a dated, photographed substrate-readiness certificate at sign-off so the next trade has documentary proof the floor was at SR2 when they arrived.
Do I need a damp-proof membrane?
Only if the moisture readings demand it. We test relative humidity in the slab with a Tramex or Protimeter; anything over 75% RH (BS 8203 limit) means we install a liquid-applied DPM before levelling. Older properties in Ongar with no original DPM almost always need one. Newer slabs from the 1990s onwards usually do not · we will tell you either way and put the readings in writing.
How long before I can fit flooring on top?
For latex feather skim: walkable in 90 minutes, ready for flooring in 4 hours. For full self-levelling compound at 3–6mm: walkable in 3 hours, ready for resilient flooring (LVT/Amtico) in 24 hours and ready for engineered wood in 48 hours. Deep-fill repairs and DPM installs run on a 72-hour cure cycle. We give you the exact handover date in writing on the quote.
Also available nearby
Subfloor Levelling in LoughtonSubfloor Levelling in ChigwellSubfloor Levelling in Buckhurst HillSubfloor Levelling in EppingSubfloor Levelling in Theydon BoisSubfloor Levelling in Woodford GreenSubfloor Levelling in WansteadSubfloor Levelling in South WoodfordSubfloor Levelling in ChingfordSubfloor Levelling in AbridgeSubfloor Levelling in Brentwood & Shenfield